| FAQ | ||
|
Question: How do I calibrate my controls? Answer: FLIGHT CONTROLS CALIBRATION ELITE will accommodate various third party flight controls. Calibration is necessary to bring these controls into proper tolerances and allow ELITE to learn the control nuances or limits of the specific devices being used. Under Controls click the SET button next to calibration. The Calibration screen is divided into three sections or “panels”. From left to right these Limits: Under Limits, click the RESET button. Notice the small cross-hairs in the box just below “Aileron/Elevator”. Now move your yoke or stick through its FULL range of motion, i.e. forward (down) elevator, back (up) elevator, full left and right aileron. The cross-hairs should have now traced a blue box which graphically represents the limits of the control device being used. If rudder pedals are connected, apply FULL left and right rudder. You will see a small vertical line move with the application of rudder input. Click 'SET' to store the new limits settings. Power Quadrant: Under 'Power Quadrant,' click "RESET". Now physically move the Mixture, Prop, and Throttle levers (if applicable) on your power quadrant (or similar device) to their halfway positions. Do NOT use lines on screen under the PWR, RPM, and MIX columns for reference. Once the levers are positioned physically at 50% (on the device) click the middle 'SET'
|
||
